FS#50832 - [freecad] Creating a loft crashes freecad
Attached to Project:
Community Packages
Opened by Juan Carlos Coruña (oggers) - Monday, 19 September 2016, 14:21 GMT
Last edited by Florian Pritz (bluewind) - Friday, 23 September 2016, 12:29 GMT
Opened by Juan Carlos Coruña (oggers) - Monday, 19 September 2016, 14:21 GMT
Last edited by Florian Pritz (bluewind) - Friday, 23 September 2016, 12:29 GMT
|
Details
Description:
When you try to create a loft from 2 sketches (doesn't matter the sketch) o 2 Drafts, freecad crashes with the following message: *** Abort *** an exception was raised, but no catch was found. ... The exception is:SIGSEGV 'segmentation violation' detected. Address 0 Additional info: * freecad version: 0.16-5 Steps to reproduce: Just load the attached test_loft.fcstd and try to do a loft selecting the two sketches in whatever order you want. |
This task depends upon
Closed by Florian Pritz (bluewind)
Friday, 23 September 2016, 12:29 GMT
Reason for closing: Duplicate
Additional comments about closing: FS#50829
Friday, 23 September 2016, 12:29 GMT
Reason for closing: Duplicate
Additional comments about closing:
Comment by
Juan Carlos Coruña (oggers) -
Monday, 19 September 2016, 14:26 GMT
Tested on freecad 0.16 on Ubuntu and it works.