FS#1021 - default grub config fails on default partition setup

Attached to Project: Arch Linux
Opened by Michael (poohsuntzu) - Wednesday, 23 June 2004, 15:37 GMT
Last edited by Judd Vinet (judd) - Wednesday, 23 June 2004, 23:00 GMT
Task Type Bug Report
Category Installation
Status Closed
Assigned To Judd Vinet (judd)
Architecture not specified
Severity High
Priority Normal
Reported Version 0.6 Widget
Due in Version Undecided
Due Date Undecided
Percent Complete 0%
Votes 0
Private No

Details

-Single primary IDE drive
-Partition setup used in conjunction with the automagic utility in the installer, meaning default partitions created by arch (mounted as /boot instead of /home, of course)
-grub default configuration -is- being used, as the settings are correct by their default nature with the default partition settings
-grub installed to MBR
-on reboot screen is filled with GRUB GRUB GRUB

Grub script fails on terminal 5 to find stage1 and stage2, even though if manually navigated to boot/grub/ they can both be seen. Possibly the script?
This task depends upon

Closed by  Judd Vinet (judd)
Friday, 20 August 2004, 17:15 GMT
Reason for closing:  Works for me
Comment by Judd Vinet (judd) - Wednesday, 21 July 2004, 00:09 GMT
I cannot reproduce this. The 0.6 install CD works fine for me.

Can anyone else?
Comment by dorphell (dorphell) - Wednesday, 18 August 2004, 16:28 GMT
I recently set up a very similar system to what Michael describes, no problem with grub either. Perhaps a bit of corruption, Michael?

Loading...