# vim:set ft=sh # MODULES # The following modules are loaded before any boot hooks are # run. Advanced users may wish to specify all system modules # in this array. For instance: # MODULES="piix ide_disk reiserfs" MODULES="ata_piix dm_mod" # BINARIES # This setting includes any additional binaries a given user may # wish into the CPIO image. This is run last, so it may be used to # override the actual binaries included by a given hook # BINARIES are dependency parsed, so you may safely ignore libraries BINARIES="" # FILES # This setting is similar to BINARIES above, however, files are added # as-is and are not parsed in any way. This is useful for config files. # Some users may wish to include modprobe.conf for custom module options # like so: # FILES="/etc/modprobe.d/modprobe.conf" FILES="" # HOOKS # This is the most important setting in this file. The HOOKS control the # modules and scripts added to the image, and what happens at boot time. # Order is important, and it is recommended that you do not change the # order in which HOOKS are added. Run 'mkinitcpio -H ' for # help on a given hook. # 'base' is _required_ unless you know precisely what you are doing. # 'udev' is _required_ in order to automatically load modules # 'filesystems' is _required_ unless you specify your fs modules in MODULES # Examples: ## This setup specifies all modules in the MODULES setting above. ## No raid, lvm2, or encrypted root is needed. # HOOKS="base" # ## This setup will autodetect all modules for your system and should ## work as a sane default # HOOKS="base udev autodetect pata scsi sata filesystems" # ## This is identical to the above, except the old ide subsystem is ## used for IDE devices instead of the new pata subsystem. # HOOKS="base udev autodetect ide scsi sata filesystems" # ## This setup will generate a 'full' image which supports most systems. ## No autodetection is done. # HOOKS="base udev pata scsi sata usb filesystems" # ## This setup assembles a pata mdadm array with an encrypted root FS. ## Note: See 'mkinitcpio -H mdadm' for more information on raid devices. # HOOKS="base udev pata mdadm encrypt filesystems" # ## This setup loads an lvm2 volume group on a usb device. # HOOKS="base udev usb lvm2 filesystems" # ## NOTE: If you have /usr on a separate partition, you MUST include the # usr, fsck and shutdown hooks. HOOKS="base udev autodetect pata scsi sata dmraid filesystems usbinput fsck" #HOOKS="base udev autodetect pata scsi sata filesystems usbinput fsck" # COMPRESSION # Use this to compress the initramfs image. By default, gzip compression # is used. Use 'cat' to create an uncompressed image. #COMPRESSION="gzip" #COMPRESSION="bzip2" #COMPRESSION="lzma" #COMPRESSION="xz" #COMPRESSION="lzop" # COMPRESSION_OPTIONS # Additional options for the compressor #COMPRESSION_OPTIONS=""